Table of Contents

---

Title Page
Table of Contents
Listing of Figures
Listing of Tables
Abstract
Authorship Page
Acknowledgements
Executive Summary

Chapter 1 – Introduction

Chapter 2 - Literature Review

2.1 Introduction to Motion Picture Projection
2.2 Projector Setups

2.2.1 Changeover System
2.2.2 Platter System
2.2.3 Platter Operation

2.3 Elements of Projection

Chapter 3 – Projector Analysis

3.1 Interviews
3.2 System Design
3.3 Current Problems
3.4 System Improvements
3.5 Choosing Components

3.5.1 Relays
3.5.2 CDS cells
3.5.3 Wire
3.5.4 Buttons, Switches, and LEDs
3.5.5 Xilinx vs. Altera

Chapter 4 – Evaluation of Current Systems

Chapter 5 – The New System

5.1 Arc Sensor
5.2 Motor Sensor
5.3 Exciter Sensor
5.4 Door Sensor
5.5 Arc Control
5.6 Motor Control
5.7 Exciter Control
5.8 Shutter Control
5.9 Changeover Control
5.10 Dolby Cinema Processor 55 Control
5.11 Manual Overrides
5.12 Recommendations and Future Enhancements

Appendix A: Motion Picture Projection at WPI

Appendix B: Pin Outs

Appendix C: Parts List

Appendix D: VHDL Code

Glossary

Bibliography

This document is the result of academic work conducted at Worcester Polytechnic Institute in Worcester, Massachusetts. The opinions expressed do not represent and should not be considered those of Worcester Polytechnic Institute. This work may not be distributed, reproduced, or retransmitted without the expressed written consent of the author.

©1998 Craig R. Hansen, All Rights Reserved.